DIY Neon Ribbon Chain Bracelet
1/10You will need
About 5" inches of 1" wide chain–you can get this at most hardware stores
2 colors of neon grosgrain ribbon in 1cm width
1 color of neon grosgrain ribbon in 1/2cm width
Scissors
2/10Tie ribbons together
Tie the three ribbons together in a knot, leaving about 2" of ribbon at the end.
3/10Weave through chain
Use a piece of masking tape to secure the ribbon tails to your work surface, and then weave the thinner ribbon through the center of the chain.
4/10Begin weaving a second ribbon
Grab one of the 1cm pieces of ribbon, and begin looping it in and around the outer edge of the chain, passing around the outside of the link, and then through the middle, right next to where the thinner ribbon is.
5/10Continue weaving through chain
Keep weaving all the way down to the end of the chain.
6/10Loop the last ribbon
When you get to the end of the chain, repeat the same looping on the opposite side with the last ribbon.
7/10Knot the ribbons
Once the last ribbon has been woven entirely down the chain, tie off all three ribbons with a secure double knot.
8/10Trim the ribbons
Cut the ribbons on the diagonal leaving two inches at the end. Tie the two ends together, and wear with pride!
9/10The finished bracelet
10/10The finished bracelet
